Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
This paper presents an improved low power heater cathode assembly structure for space-TWT. Several factors were involved in power efficiency of heater cathode assembly, such as heat shield thickness, structure. Experimental result shows Heater power can decrease to 2.5W when cathode temperature is 950°C Simulation using ANSYS software on these change in heater cathode assembly was achieved.
The oxide cathode presented here is a reservoir dispenser oxide cathode based on the improved designs of the structure with a reservoir cell, the Ni sponge with the controlled porosity, and the emission materials in the cell. Its excess Ba comes from the reservoir emission material in the cell of the cathode. The excess Ba can easily diffuse to the surface of the cathode to emit electrons through...
It is necessary to know the actual temperature of a thermionic cathode that works as the electron source in a microwave tube. It has been found that the temperature of the cathode drops markedly during the thermionic emission. For example, the temperature could fall by about 30°C under a current density of 2.92 A/cm2. Using the molecular thermodynamics, the dependence of the cathode temperature on...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.