Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
Digital signal processing for Global Navigation Satellite System (GNSS) receivers is mostly based on the assumption that the noise at the receiver input is Gaussian. This assumption leads to a non-linear Least Squares (LS) problem where GNSS signal parameters are estimated by minimizing a quadratic cost function. The receiver performance can be however significantly degraded by non-Gaussian phenomena...
This paper presents details about the theoretical background as well as implementation of a GNSS interference monitoring system that can be used to continually monitor the GNSS frequency bands and thus alert users depending on the reliability of GNSS measurements. As shown in the results section, events of intentional GNSS interference are successfully detected and the system can also be used to classify...
An interference monitoring station is presented which detects, characterises and logs interference events. The system operates autonomously and continuously over multiple global navigation satellite system (GNSS) bands. With a bandwidth of up to 80 MHz, input resolution of 8 bit an overall data rate of approximately 1.3 Gbit/s can be supported. The interference detection is carried out in real-time,...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.