Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
The theory, design, fabrication and measurements of a MEMS equalizer for adjusting the microwave signals are presented. The novelty of the equalizer is the CPW line with released signal and ground sections based on the MEMS technology. In this method the work frequency can be achieved higher and the minimal insertion losses can be greatly reduced due to the dielectric losses. The MEMS equalizer is...
To improve microwave characteristics and the frequency response, and achieve the state conversion, an inline RF MEMS power sensor with an impedance matching structure and a capacitance compensating structure, and two shunt capacitive MEMS switch structures is presented in this paper. This power sensor is accomplished with GaAs MMIC technology. In detection state, experiments demonstrate that the improved...
In order to improve microwave characteristics and the frequency response of the output thermovoltage at X-band, an inline RF MEMS power sensor with the impedance matching and compensating capacitance structures is presented in the paper and the sensor is accomplished with GaAs MMIC process. The measured results show that the reflection loss of the sensor is less than -17 dB and the insertion loss...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.