Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
Distribution Automation (DA) could realize fault location, isolation and service restoration (FLISR), which is an important means of improve power supply reliability. Generally, to perform power supply restoration, the operator needs to know the position of tie-switch, which may vary due to structure changes in the distribution network. As a solution, a kind of distributed tie-switch identification...
A new overcurrent fault isolation technology in distribution line based on network is presented. The FTU detects fault and exchanges fault data with the adjacent FTUs by peer-to-peer communication technology. The FTUs at both ends of the faulted section will trip the circuit breakers to isolate the fault. Then FTU at the tie breaker will close the tie breaker to restore supply.
A new fault location method for distribution automation of active network is presented. It compares the phase angle of fault currents at both ends of a feeder section when the fault current contribution of downstream distributed generation also exceeds overcurrent setting. The measurement of phase angle is synchronized by the fault itself, and the fault is detected by comparing the current deviation...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.