Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
A new paradigm in inertial sensing is presented based on measurement of accurate time intervals using physical proximity switches deposed on a resonanting beam structure. This paper discusses the time domain sensing concept and noise sources that can influence the performance of the sensor. The ultimate noise floor (−178 dB/√Hz)is limited by the accuracy of a time-to-digital convertor.
A novel means of measuring inertial force is proposed which converts the spatial displacement measurement of a conventional mass-on-a-spring accelerometer to a time interval measurement by harmonically oscillating the mass-on-a-spring and creating digital triggering events when the mass passes known displacement points. By curve fitting the measured time intervals into the sinusoidal nature of the...
A closed-loop control system for a MEMS gyroscope is proposed which greatly restricts the mechanical freedom of the sense mass while accurately measuring the total external force acting upon the sense mass. This is realized by an algorithm which uses the previous three sense mass position measurements to generate a position-, velocity-, and acceleration-dependant feedback force on the sense mass....
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.