Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
A detailed structural analysis of the (AgCu)(InGa)Se 2 thin film alloy system was undertaken via X-ray diffraction in order to determine its phase behavior and the chalcopyrite phase lattice constants of the alloy system. Thin films were grown by elemental co-evaporation with time-invariant flux, for the compositions 0≤[Ag]/([Cu]+[Ag])≤1 for fixed [Ga]/([In]+[Ga])=0.5. Lattice constants were...
The study of (AgCu)(InGa)Se2 absorber layers is of interest in that Ag-chalcopyrites exhibit both wider bandgaps and lower melting points than their Cu counterparts. (AgCu)(InGa)Se2 absorber layers were deposited over the composition range 0 < Ag/(Ag+Cu) < 1 and 0.3 < Ga/(In+Ga) < 1.0 using a variety of elemental co-evaporation processes. Films were found to be single-phase over the entire...
A Three-step selenization process consisting of H2Se/Ar/H2Se reaction was employed to mitigate adhesion and Ga homogeneity problems in the formation of Cu(InGa)Se2 films. In particular, reaction conditions for the 3rd step have been experimentally optimized to address these issues. The Cu(InGa)Se2 films prepared by three-step selenization using H2Se/Ar/H2Se sequentially at 400/550/500??C with the...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.