Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
The cabin temperature increases sharply and can reach 70°C when the vehicle parks in the summer direct sunlight, which has a bad influence on the occupants entering comfort. At first, based on the theory of thermal, static heat transfer model of cabin is established and the rule of the indoor air temperature changing with time is obtained. After that, ventilation cooling model for car blower is set...
A powder metallurgical technology of low temperature and pressureless is used to fabricate a W-20wt.%Ti alloy using milled TiH 2 powders and micro-sized W powders. The microstructure of the milled TiH 2 powders and the bulk W–Ti alloy were studied. It is indicated that TiH 2 nanoparticles with the size of 8 to 15nm were obtained after milling for 48h and the decomposition temperature...
W–Ti–N films were prepared on a Si wafer by reactive sputter-deposition, followed by a deposition of a Cu thin film by DC magnetron sputtering. The Cu/W–Ti–N/Si samples prepared were annealed at different temperatures under vacuum and then characterized using X-ray diffraction, scanning electron microscopy and auger electron microscopy. The sheet resistivity was determined by four point probe analysis...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.