Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
Several studies have shown that the coefficient of friction of self-mated silicon nitride in water decreases from an initially high value to about 0.002 after a certain run-in period. Since the worn surfaces become extremely smooth, the low friction is attributed to the initiation of hydrodynamic lubrication by a thin water film at the interface. The possibility of mixed lubrication, i.e., hydrodynamic...
The machining characteristics and material removal mechanisms of two dental ceramics-feldspathic porcelain and yttria-stabilized tetragonal zirconia-were investigated using a dental handpiece and diamond burs with different grit sizes. The material removal rates were measured as a function of total machining time using a constant load of 2N on the bur, consistent with clinical cutting conditions....
The fretting wear behaviour of silicon nitride against silicon nitride was investigated under lubricated conditions as a function of fretting amplitude and duration. Amplitudes in the intermediate 5–50 μm range and test durations from 10 to 360 min were studied, using the commercial lubricant ISO VG 220. Light microscopy, scanning electron microscopy, transmission electron microscopy and energy dispersive...
Sliding contact of a cylindrical steel pin on an oxygen free high conductivity (OFHC) copper flat was numerically simulated and the results were compared with experimental measurements. The numerical simulations were performed using EPIC II, an elastic-plastic, 2D finite element code which uses a Lagrangian formulation and triangular mesh. This code can accommodate very large deformations, large strains...
To obtain information on the tribological behaviour of silicon carbide at elevated temperatures, unlubricated ball-on-flat wear tests were conducted on sintered silicon carbide in self-mated sliding in air. The contact load was varied from 3.2 to 98.0 N, and a temperature range of 23°C to 1000°C was used. Scanning electron microscopy, Fourier transform infrared spectroscopy and energy-dispersive...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.