Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
This paper proposes a Low Cost circuit level Fault Detection technique called LCFD for a one-bit Full Adder (FA) as the basic element of adder circuits. To measure the fault detection coverage of the proposed technique, we conduct an exhaustive circuit level fault injection experiment on all susceptible nodes of a FA. Experimental results show that the LCDF technique can detect about 83% of injected...
In this paper, we present a very fast and accurate technique to estimate the soft error rate of digital circuits in the presence of Multiple Event Transients (METs). In the proposed technique, called Multiple Event Probability Propagation (MEPP), a four-value logic and probability set are used to accurately propagate the effects of multiple erroneous values (transients) due to METs to the outputs...
In this paper, we propose a very fast and accurate analytical approach to estimate the overall SER and to identify the most vulnerable gates, flip-flops, and paths of a circuit. Using such information, designers can selectively protect the vulnerable parts resulting in lower power and area overheads that are the most important factors in embedded systems. Unlike previous approaches, the proposed approach...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.