Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
Digital image correlation (DIC) is of vital importance in the field of experimental mechanics, yet producing suitable DIC patterns for demanding in‐situ (micro)mechanical tests remains challenging, especially for ultrafine patterns, despite the large number of patterning techniques reported in the literature. Therefore, we propose a simple, flexible, one‐step technique (only requiring a conventional...
In this research, the correlation between the stress concentration and the residual magnetic field (RMF) of 30Cr steel was investigated. Tensile tests were carried out to measure the RMF signals on the surface of U‐shaped defect specimens. It was found that the tangential RMF signal at the defect area is correlated to the applied load and the stress concentration factor. A new method based on magnetic...
The strain path may change in actual sheet metal‐forming processes, so the determination of formability of sheet metal should consider the nonlinear strain path. For identifying the forming limit (FL) strains under nonlinear strain path, a conventional two‐step procedure with unloading is classically used to produce the strain path change, which results in no continuous measure of strain. The in‐plane...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.