Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
This work targets modular nanogrids for remote locations, where photovoltaic modules can be gradually introduced to grow the renewable energy capacity at minimal capital cost, while reducing diesel fuel consumption. Today's grid-tied micro-inverters provide a modular solution for ac power generation in nanogrids but battery storage remains centralized, requiring an additional ac-dc converter. The...
A family of single-stage converters called Reconfigurable Solar Converter (RSC) is presented for integration of energy storage with a PV system where ramp-rate control and peak-shifting is desired. An algorithm designed to reduce the variability of photovoltaic (PV) power output by using a battery demonstrates the PV power output smoothing. The purpose of the battery is to add power to the PV output...
This paper presents a distributed battery energy storage architecture where the cells in the battery pack are decoupled from each other by connecting each cell with a lower power (smaller) DC-DC power converter. In addition to providing voltage regulation for the DC bus, these small DC-DC power converters are utilized to achieve state of charge (SOC) balancing among the cells by employing a proposed...
This paper introduces a new battery management system for portable electronics applications based on the flyback converter. This new architecture integrates the voltage step-up and balancing functions inside a single converter. The step-up function is obtained using an assisting concept, where the flyback output is placed at the top of the battery pack and is therefore only processing a portion of...
A microgrid is an integration of distributed energy sources, loads and energy storage systems. Indeed, energy storage systems are required in order to ensure reliability and power quality because of the intermittent nature of renewable energy sources and changes of load demand. Apart from that, the use of distributed energy storage units provides redundancy to the system and support possible increments...
This paper proposes a novel control scheme for a stand-alone PV application. A two power stage approach has been used that consists of a front end high gain DC-DC converter followed by a 3φ H-bridge inverter. A general reactive load has been considered. The control scheme uses abc to dq reference frame transformation. The active power demand is controlled by regulating the dc link voltage. Reactive...
This paper proposes a new distributed battery energy architecture based on the micro-bank modules for DC microgrids. The benefits of the proposed architecture include 1) no voltage sharing problem and no overcharge/overdischarge problem; 2) high compatibility and reliability 3) high energy utilization efficiency; 4) reduced volume and weight of the BMS. Taking advantage of the battery recovery effect,...
This paper studies the characteristics of battery packs with parallel-connected lithium-ion battery cells. To investigate the influence of cell inconsistency problem in parallel-connected cells, a group of different degraded lithium-ion battery cells were selected to build various battery packs and test them using a battery test bench. The physical model was developed to simulate the operation of...
Electric-drive vehicles, including hybrid (HEV), plug-in hybrid (PHEV) and electric vehicles (EV), require a high-voltage (HV) battery pack for propulsion, and a low-voltage (LV) dc bus for auxiliary loads. This paper presents an architecture that uses modular dc-dc bypass converters to perform active battery cell balancing and to supply current to auxiliary loads, eliminating the need for a separate...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.