The Infona portal uses cookies, i.e. strings of text saved by a browser on the user's device. The portal can access those files and use them to remember the user's data, such as their chosen settings (screen view, interface language, etc.), or their login data. By using the Infona portal the user accepts automatic saving and using this information for portal operation purposes. More information on the subject can be found in the Privacy Policy and Terms of Service. By closing this window the user confirms that they have read the information on cookie usage, and they accept the privacy policy and the way cookies are used by the portal. You can change the cookie settings in your browser.
A ring-shaped transverse flux permanent magnet (TFPM) generator with double-sided axial flux configuration is proposed in this paper. The ring-shaped TFPM generator does not use a shaft and arms to transfer the torque and to support both the rotor and the stator. The active part of the proposed generator consists of multiple-segment structure. This new generator configuration can remarkably reduce...
Parallel dimming for reducing the intensity of high power light-emitting diode (HP-LED) is an effective way of achieving high contrast ratio and wide dimming range. However the scheme has limitation due to response of control loop and higher power dissipation due to losses during turn-off period. Therefore shorting-inductor approach is proposed in this paper which is capable of achieving improvement...
In this paper, we propose the method to realize high efficiency control for IPMSM (Interior Permanent Magnet Synchronous Motor). In this method, we pay attention to the torque equation. We realize high efficiency control by controlling the vector angle of stator current. As for the high efficiency control, we define the optimum angle as the stator current angle which makes the torque biggest against...
This paper proposes a novel phase-shift plus duty cycle controlled hybrid bi-directional DC-DC converter based on fuel cells and supercapacitors. The described converter employs two high frequency transformers to couple the half-bridge and full-bridge circuits together in the primary side and voltage doubler circuit in secondary side. Boost type converter can limit the output ripple current of the...
Contactless power transmission system with the advantages of safety and convenience has been applied to daily supplies. However, general contactless power transmission charger cannot control the current cause there is no charge controller in secondary side and the severe limitation between primary and secondary sides of the battery charger cause difficulty to design. This study provides the charge...
This paper proposed a model of contactless power transfer system (CPTS), which adopted a transformer with big air-gap and long primary wires. The system has the characters of long leakage inductance, small magnetizing inductance and low coupling coefficient. It makes the transmission efficiency very low, this model improved system efficiency by adopting resonance of compensation capacitance and leakage...
This paper is concerned with some experimental results and practical evaluations of a three-level phase shifted ZVS-PWM DC-DC converter with neutral point clamping diodes and flying capacitor for a variety of gas metal arc welding machines. This new DC-DC converter suitable for high power applications is implemented by modifying the high-frequency-linked half bridge soft switching PWM DC-DC converter...
This paper discusses the performance of a single-phase induction motor drive under nominal load in a closed-loop vector-controlled system. The control strategy to be applied is known as indirect field oriented control. Single-phase induction motor when operating as two-phase motor has its dynamic performance increased. With the use of a standard three-phase voltage-source inverter, space vector pulse...
Inductor-less half-bridge piezoelectric transformer based resonant converters can offer considerable reductions in mass and form factor over their discrete counterparts. This work presents an analytical model for calculating the load and frequency range over which such converters can achieve ZVS given the large input capacitance these transformers typically present.
A novel stator voltage oriented V/F control method for induction motor is presented in this paper to improve the low speed performance and stability of open-loop system. The control scheme adopts a novel stator resistor voltage drop compensation method to ensure the rated stator flux constant over a wide range of operating speeds. And through deeply research of the instability under light load condition,...
This paper presents a simple overmodulation method employed in direct torque control (DTC)-constant switching frequency (CSF) controller of induction machines. The proposed overmodulation method is utilized to extend a constant torque region and hence produces high torque capability in field weakening region with six-step operation. It will be shown that the overmodulation operation using the DTC-CSF...
Flyback converters are widely used in consumer electronic products and other applications that require low cost isolated power supply with less than or around 200W output power. Transition Mode is one method to control the Flyback converters. This control method has the advantage of soft-switching turn-on, which greatly reduces the turn-on loss. This paper discusses the design of a CMOS Transition...
A new feedback control method of using field-programmable gate array (FPGA) chip for ultrasound welding system is appeared in this article. This feedback control circuits of ultrasound welding system consists of microprocessor control unit, signal generator, power amplifier, the feedback of voltage detector and current detector, etc. The experimental results exhibited this feedback control method...
In this paper, a two-phase interleaved boost converter with low switch voltage stress and automatic current-sharing capability is proposed for single-phase power factor correction (PFC). First, a forward-type converter is integrated with the first phase to achieve much higher voltage conversion ratio and avoid operating at extreme duty ratio. Then, two capacitors are added as voltage dividers for...
The coupling of the windings can be easily increased by using multiply stacked planar windings connection. Interleaving is a well-known technique used to reduce leakage inductance and minimize high-frequency winding losses. The paper aims to analyze leakage inductance based on magneto motive force (MMF) and energy distribution in planar transformer and correct the formula of leakage inductance proposed...
This paper proposes a black box approach which synthesizes lumped circuit model of the Foster type for a frequency-dependent characteristic element by the least squares method systematically. However there are two numerical difficulties to model them. One is the numerical stability problem which comes from limitation of effective numerical digits of data especially for wide frequency band ranges....
In order to design a high performance power electronics circuit, a precise simulation environment is essential for the controller design. In this paper, a power electronic circuit real-time simulator was designed and realized on a DSP chip. The dynamic equations of a power electronics circuit were coded on a Texas Instruments (TI) made C6416 fixed point DSP. Meanwhile, the interrupt interface of the...
This paper is concerned on FPGA design for control implementations of four switch three phase inverters (B4, FSTPI). This paper is to present a space vector PWM algorithm for four switch three phase inverters (B4, FSTPI) based on the one for six switch three phase inverters (B6, SSTPI) (principle of similarity) where the ???? plan is divided into 6 sectors and the formation of the required reference...
In this paper, an impedance-compensated battery charger is presented to increase the effective capacity of the lithium-ion/lithium-polymer battery. The proposed charger adopts a pulsating current source associated with a pulsating voltage detector to dynamically estimate compensated impedance of battery. With this approach, the discharge-time is extended 12% and the overall battery capacitor is increased...
This paper presents flyback converter combined with single-capacitor turn-off snubber for auto-tuning fan rotational speed system. The proposed system can automatically regulate rotational speed of fan, depending on temperature in the chassis of the equipments. Its control algorithm is to regulate output voltage of the proposed converter. With this approach, the wear and tear of the bearing of fan...
Set the date range to filter the displayed results. You can set a starting date, ending date or both. You can enter the dates manually or choose them from the calendar.