Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
This paper presents the test results of the swift krypton (240MeV) and xenon ion (130MeV) irradiation influence on the titanium surface layer properties. These ions change the titanium surface topography in different ways. The irradiation contributes to the creation of a new phase in the surface layer. Radiation damage effects on the friction coefficient, wear, and microhardness of titanium after...
The microstructure and the arc chopping current of melt-spun Cu 71 Cr 29 ribbon added by Ti–Zr are studied in the article. The results reveal that the melt spinning could partly restrain the liquid phase separation of CuCr alloys because it has a high cooling rate (about 10 6 K/s), the size of the Cr rich phase from liquid phase separation in the Cu 71 Cr 29 ...
A middle-frequency (MF) unbalanced magnetron sputtering system equipped with an electron source was designed and used for deposition of CrN thick films under various MF power (1.4–14kW) at fixed temperature, pressure, and gas flow rate. The deposition rate was increased with increasing MF power and the structure and N/Cr ratio of the deposited CrN films exhibited a complicated behavior, where the...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.