This study compared the residual monomer (RM) in four hard chair-side reline resins (Duraliner II-D, Kooliner-K, Tokuso Rebase Fast-TRF and Ufi Gel hard-UGH) and one heat-polymerized denture base resin (Lucitone 550-L), which was processed using two polymerization cycles (short-LS and long-LL). It was also investigated the effect of two after polymerization treatments on this RM content.Specimens (n=18) of each material were produced following the manufacturers’ instructions and then divided into three groups. Group I specimens were left untreated (GI-control). Specimens of group II (GII) were given post-polymerization treatment by microwave irradiation. In group III (GIII), specimens were submitted to immersion in water at 55°C (reline resins-10min; denture base resin L-60min). The RM was analyzed using high performance liquid chromatography (HPLC) and expressed as a percentage of RM. Data were analyzed by two-way ANOVA followed by Tukey's test (α=0.05).Comparing control specimens, statistical differences were found among all materials (p<0.05), and the results can be arranged as K (1.52%)>D (0.85%)>UGH (0.45%)>LL (0.24%)>TRF (0.14%)>LS (0.08%). Immersion in hot water (GIII) promoted a significant (p<0.05) reduction in the RM for all materials evaluated compared to control (GI), with the exception of LL specimens. Materials K, UGH and TRF exhibited significantly (p<0.05) lower values of RM after microwave irradiation (GII) than in the control specimens.The reduction in RM promoted by water-bath and microwave post-polymerization treatments could improve the mechanical properties and biocompatibility of the relining and denture base materials.