In this paper, the intermetallic compounds formation during dissimilar friction stir welding of brass to aluminum 1050 and its effect on the mechanical behavior of joint were studied. Scanning Electron Microscopy (SEM), Energy dispersive spectroscopy analysis (EDS) and X-ray Diffraction analysis were used to characterize intermetallics. In addition, tensile tests and microhardness measurements were performed to evaluate mechanical properties. The results showed that utilizing rotation speeds higher than 400 rpm leads to gradual formation of intermetallic compounds in the stir zone and at the interface. CuAl 2 is the dominant compound in the composite structure of the stir zone, whereas four intermetallic bands are detected at the interface. From aluminum to brass, two middle layers were formed. Then, CuAl 2 , Cu 9 Al 4 and CuZn were detected. The increase in rotation speed is accompanied by thickening and development of interfacial intermetallic compounds. The optimum rotation speed of 450 rpm yielded a narrow interfacial intermetallic compound and a lamellar composite structure within the stir zone which enhances the tensile strength of the weld. On the other hand, further increase of rotation speed lowers the tensile strength of the weld which is accompanied by disappearance of lamellar composite structure, increment of weld defects and thickening of interfacial intermetallic layer.