Signal broadening using electrothermal vaporization with inductively coupled mass spectrometry (ETV-ICPMS) occurs at a rate much faster than would be predicted by simple longitudinal diffusion. A Monte Carlo simulation that focused on particle motion within the transport tubing was created to elucidate the causes of this dispersion within ETV-ICPMS. Several parameters, including the diffusion coefficient, tube diameter, transport tube length, and flow rate were varied to discern their role in signal broadening. Using typical instrumental parameters, the parabolic flow profile generated by laminar flow of the carrier gas was shown to be the primary cause of dispersion. Manipulating the aforementioned variables to lessen the effects of laminar flow led to a decrease in dispersion. Conversely, increasing the role of laminar flow promoted broadening. The broadening processes should be applicable to any transient introduction system where material must be transported to a detection system. Due to the difference in the rate of broadening expected for particles of different sizes, the simulation was used to calculate the average size of particles generated in the ETV using different mass amounts of sample. No change in particle size (~1 nm) was seen for mass amounts ranging from 10-10000 pg, which suggests that the particle number is increased with increasing sample mass rather than the average particle size. Using this method of determining particle size, it might be possible to further evaluate the mechanisms of physical 'carrier' action.