In this review, particulate materials are studied using the Discrete Element Method (DEM), where the particles keep their identity throughout. Loose particles can sinter due to time-, stress- or temperature-dependent forces. Large deformations of sintered samples will then lead to damage. Self-healing of damaged samples can be activated through resintering, a process that increases further the contact adhesion between particles. Initially, the particle-samples are prepared by applying isotropic (hydrostatic) pressure. The spherical particles deform plastically at contact and stick to each other due to strong, non-linearly increased van der Waals forces. Such pres-sure-sintering results in a solid sample with (after releasing pressure) zero conflning stress - on which uni-axial tension or compression can be applied. Damage can occur through loss of contacts and/or loss of adhesion and more damage will occur with increasing deformation. In order to trigger "self-healing at different damage levels, the mechanical loading is first stopped, second, the system is resintered (so that the adhesion at existing contacts in the damaged sample becomes stronger than originally), and third, mechanical loading is continued with the healed sample, in order to study the material properties after the healing event.
W artykule zamieszczono przegląd badań wybranych mate-riałów z zastosowaniem metody elementów dyskretnych (ang. Discrete Element Method - DEM), w której poszczególne cząstki zachowują swoją odrębność. Pojedyncze cząstki ulegają spiekaniu pod wpływem sił zależnych od czasu, naprężenia i temperatury. Duże odkształcenia spiekanych próbek mogą prowadzić do ich zniszczenia. Samo-zaleczanie zniszczonych próbek może być wywołane poprzez ponowne zgrzewanie, czyli proces który powiększa obszar adhezji pomiędzy cząstkami. Wstępne przygotowanie cząstek-próbek jest wykonywana przez zastosowanie izotrpowego (hydrostatycznego) ściskania. Sferyczne cząstki odkształcają się plastycznie w obszarze styku i przywierają do siebie w wyniku znacznego, nieliniowego wzrostu sił van der Waalsa. Spiekanie pod ciśnieniem prowadzi do powstania litych próbek, w których po zdjęciu obciążenia zanikają naprężenia na granicach. Takie próbki mogą być poddane próbom rozciągania lub ściskania. Zniszczenie może wystąpić poprzez utratę styku i/lub zanik adhezji, a rozwój pęknięcia postępuje wraz ze wzrostem odkształcenia. Aby wywołać samo-zaleczanie uszkodzeń na różnych etapach zniszczenia, obciążenie mechaniczne jest najpierw zdejmowane a następnie system jest poddawany ponownemu zgrzewaniu tak że adhezja w obszarach styku cząstek w zniszczonej próbce staje się mocniejsza niż w początkowym etapie. Następnie obciążanie mechaniczne jest kontynuowane w próbce aby umożliwić zbadanie ich własności po zaleczeniu.