Przeprowadzono doświadczenia związane z otrzymywaniem włóknistych kryształów gipsu i anhydrytu w wyniku krystalizacji tych faz z przesyconych roztworów kwasu siarkowego. Materiały złożone z tych kryształów nasycano żywicami silikonowymi uzyskując tworzywa o właściwościach zbliżonych do wełny mineralnej. Udział polimerów w tym tworzywie wynosił około 50%. Uzyskany materiał wykazał odporność na działanie wilgoci, a nawet wody, w przypadku całkowitego zanurzenia próbek w ciągu 24 godzin. W tych doświadczeniach wykazano brak uwodnienia anhydrytu, co wskazuje na szczelność osnowy silikonowej. Poddanie tworzywa działaniu podwyższonych temperatur, sięgających 500oC nie powoduje rozpadu kompozytu, pomimo odwodnienia gipsu. Także wzrost temperatury do 250oC, w przypadku nasycenia kompozytu żywicami sieciującymi, nie powoduje utraty dobrych właściwości fizycznych. Właściwości ważne dla zastosowań termoizolacyjnych, a mianowicie gęstość mieści się w przedziale 0,25 do 0,40 g/cm3, a przewodność cieplna przyjmuje wartości od 0,045 do 0,06 W/m•K, są na dobrym poziomie.
The paper presents the experiments of formation of needles morphology of gypsum and anhydrite as the result of crystallization from oversaturated solution of sulphuric acid. The materials composed of these needles crystals were impregnated with silicone resins giving the composite of the properties similar to mineral wool. The content of polymers in this composite was about 50%. The produced material was resistance to moisture and even to water, in the case of total immersion of the samples during 24 h. These experiments showed the stability of anhydrite, which proofs the tightness of silicone matrix. The heating of composite up to 500°C did not cause the destruction of samples despite of gypsum dewatering. Also the increase of the sample temperature to 250°C does not provoke the decrease of the good physical properties of specimens in the case of their impregnation with crossIinking resins. The properties important for thermo-insulation applications i.e. the density is in the range 0.25 - 0.40 g/cm3 and thermal conductivity coefficient in the range 0.045 - 0.06 W/m K are on the good level.