Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
This paper presents a response-translation technique to realize an ultra-low-cutoff lowpass filter in small area for biopotential acquisition systems. It is by exploiting a chopper-stabilized instrumentation amplifier (IA) with bandpass characteristic to obtain a lowpass response after chopper stabilization, resulting in substantial area savings because of relaxed time constant in the implementation...
This paper describes a 90 nm CMOS low-noise low-power biopotential signal readout front-end (RFE). The front-stage instrumentation amplifier (IA) features a chopper; an AC-coupler and a novel chopper notch filter for minimizing the DC-offset; transistors' flicker noise and 50 Hz powerline interference concurrently. A noise-aware transistor selection (thin- and thick-oxide) in the IA enables a flexible...
Presented is a novel powerline notch filter embeddable into a chopper-stabilised instrumentation amplifier for biopotential measurements. The frequency-translation property of the chopper enables the powerline notching to be indirectly implemented by two resonant zeros around the chopper frequency, resulting in substantial silicon area savings. Transistor-level implementation in 90 nm CMOS using a...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.