Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
The paper presents an analysis of the surface layer of Fe-Mn-C-B-Si-Ni-Cr alloy coating after friction with C45 steel. The coatings were obtained by arc welding (GMA). Flux-cored wires were used as a welding material. The flux-cored wires had a diameter of 2.4 mm. The tribological assessment was performed with the Amsler tribotester under dry friction conditions at unit pressures 10 MPa. The use of...
Dental practice today used a lot of different materials. This paper evaluates tribological and mechanical properties of two dental materials CeramX and I-Light. Tribological analysisad of samples was conducted at temperature 37°C and in the environment of artificial saliva. The wear rate was evaluated with a ball-on-disc tribotester, in accordance to ASTM G-133 norm. The counterbodies were 6-mm-in-diameter...
The paper assesses the tribological properties of hardfacing coatings produced by gas metal arc welding. Flux-cored wires were used as a welding material. The core mixture was based on the Fe Mn-C-B-Si-Ni-Cr alloy. Seven types of flux-cored wires with different compositions were prepared. The flux-cored wires had a diameter of 2.4 mm. The tribological assessment was performer with an Amsler tribotester...
Tribological behaviour of coatings obtained from eutectic alloy Fe-Mn-C-B-Si-Ni-Cr was studied. The coatings were obtained by the method of gas metal arc welding (GMA) with use of powder wire. GMA welding method is widely used for the regeneration of machine parts. Eutectic Fe-Mn-C-B-Si-Ni-Cr alloys can be used to obtain high quality coatings resistant to wear and corrosion. Pin-on-disk dry sliding...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.