Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
The fourth China TF conductor sample (TFCN4) for Phase II, the left leg of the fifth China TF conductor sample (TFCN5) for Phase III, as well as the right leg of the TFCN5 conductor for Phase IV, were made of the WST strands, cabled by Baosheng, jacketed at ASIPP, and prepared by CRPP following the IO-approved procedure and tested in the SULTAN facility. The $T_{cs}$ test results show that both legs...
This paper reports the results of an ongoing bilateral key comparison at 10 kΩ resistance standards between KRISS and the BIPM. Two 10 kΩ travelling resistance standards of the BIPM were measured at KRISS against a 100 Ω transfer standard by using a homemade cryogenic current comparator (CCC) bridge system. The value of the transfer standard resistor maintained at KRISS is calibrated against the quantized...
At KRISS we have recently developed a quantum Hall resistance (QHR) standard system adopting a cryogenic current comparator bridge, a He-3 cryostat with a 12 T superconducting magnet, and a home-made air bath with a temperature stability of 23.000°C ± 0.005°C. The performance of the system was verified by calibration of a standard resistor 100 Ω against the QHR at plateau i = 2, RH(2). The combined...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.