Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
A carbon fiber preform was chemical vapor infiltrated with a pyrocarbon (PyC) interphase and a SiC matrix, and then coated with a SiC outer layer by chemical vapor deposition to prepare 2D C/SiC composites with a density of 2.1g/cm3. The composites were oxidized at 700, 1000, 1300°C for 2, 5 and 10h, respectively. The damping behavior of the oxidized composites was measured by a dynamical mechanical...
The erosion resistance of the needled carbon/carbon composite leading edge was investigated by exposure to the solid rocket motor (SRM) plume. The erosion morphology and microstructure were examined and associated erosion mechanisms discussed. The composite leading edge was severely damaged with large recession and erosion rate after exposure. The results suggest that the erosion behavior was determined...
The ablation of pierced C/C composite nozzles was investigated via hot-fire testing by an oxygen/ethanol combustion gas generator simulating combustion environments of the liquid rocket engine. Ablation microstructures and mechanisms of the composite nozzle were discussed. The results showed that both linear ablation rate and mass ablation rate increased with increasing mass ratio of oxygen/ethanol...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.