Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
State-of-the-art commercial placement tools have as goals to optimize area, timing, and power. Over the years, several reliability oriented placement strategies have been proposed with distinct goals, such as to improve the error rate. However, we found that there are still improvements that can be made for this type of approach, to improve not only the error rates but also the performance of the...
Commercial off-the-shelf (COTS) components are increasingly being employed in embedded systems due to their high performance at low cost. With emerging reliability requirements, design of these components using traditional hardware redundancy incur large overheads, time-demanding re-design and validation. To reduce the design time with shorter time-to-market requirements, software-only reliable design...
The effect of Single-Event Transients (SETs) (at a combinational node of a design) on the system reliability is becoming a big concern for ICs manufactured using advanced technologies. An SET at a node of a combinational part of a circuit may propagate as a transient pulse at the input of a flip-flop and consequently latches in the flip-flop, thus generating a soft-error. When an SET is combined with...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.