Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
In order to make more profound comprehension of propagation characteristics for E-M signals from partial discharge in GIS, the GIS models with isolating switch are creation to analysis the E-M wave propagation characteristics using FDTD method. The influences of the isolating switch and difference receive degree on the propagation characteristics of E-M wave with comparison of isolating switch close...
Gas insulated switchgear (GIS) is the most important equipment in the power grid. Especially, for insulation failure, the monitoring, analysis and pattern recognition technology of partial discharge in GIS is the most important. Thus a 220 kV GIS bus bar cavity was taken as an object to design three PD physical models. The PD signals on different defects were detected with the IEC60270 method. The...
Partial Discharge (PD) happened in GIS may induce the failure of the apparatus and endanger the safety of the grid. Detection of PD with UHF sensor can find the defect earlier. In this a paper, a de-noising method based on the wavelet method is introduced to improve the accuracy of PD detection. The general wavelet de-nosing procedures are described in the paper, after that, the proposed algorithm...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.