Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
Considering that solder surface may lose its brightness due to oxidation during the assembly and operation of electronic device, this study investigated the surface properties of Sn-Cu-Ni solders using UV-visible and X-ray photoelectron spectroscopies. The degree of discoloring could be evaluated by the reflectance of the sample surface in the visible light range. Two distinct absorption peaks respectively...
In this work, the SAC solder joints with minor Mn or RE (rare earth) additions were bonded on the substrate of OSP Cu surface finishes for evaluating the influence of minor alloying on BIT (ball impact test) behavior. The Mn-doped samples had a better resistance to the degradation in BIT performance suffering long time aging at 150??C. The greater impact force and toughness compared to the other samples...
This study investigates the effect of alloying additives on the solidification behavior and microstructural characteristics from a metallurgical perspective. Results show that alloying of Mn and Ti resulted in dramatically reduced undercooling coarse eutectic structure and extended volume fraction of proeutectic Sn of which the dendritic size was refined. Those thermal and microstructural changes...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.