Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
Threshold voltage (VTH) needs to be well controlled to determine the switching point of the transistors. However VTH variation was observed on high voltage transistor during development phase. Investigations show that the VTH variation was caused by phosphorus contamination from wafer backside. Various wet chemical cleaning methods were evaluated to understand the effectiveness for the phosphorus...
Crack is a main destroyed formation of high-intensity mining. Based on measured data, the difference between cracks caused by high-intensity mining and other mining methods had been studied. Control cracks showed obviously when using high intensity mining, and often gone with many small cracks. They always showed as couple, and the ground between them appeared as horst or rift valley, which destroyed...
Rigid-viscoplastic finite element method is used to analyze precision forming process of the speed-reducer shaft of auto starter. And the varying rules of extruding forces, velocity, stress, strain as well as metal fluent regulation were obtained. The forming defects occurring in practice were predicted well. This research plays a guiding role on the simulation of the cold forging and the design of...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.