Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
A novel flying-capacitor-clamped five-level inverter based on bridge modular switched-capacitor topology is proposed in this paper. The inverter features the switched-capacitor circuit with dc–dc boosting conversion ability and the multilevel inverter circuit with flying-capacitor-clamped performance. With the special composite structure, the number of components is cut down compared to the topology...
This paper presents a 0.8V analog front-end (AFE) with referenceless time-based digitalization architecture for electrocardiogram (ECG) signal acquisition. Compared to the conventional voltage-domain architecture, the proposed AFE achieves a smaller chip area, lower power consumption, and self-calibration without the high-accuracy clock as well as voltage reference. The chip is fabricated using 0...
This study develops a dual-path cross-correlation technique and a single-path cascade method for phase noise and transient measurements up to the V-band frequency region. Further, this paper presents the complete test setup and test procedure. Results of the analyses of the single-path cascade measurement method and the signal-to-noise ratio (SNR) floor effects are also discussed in detail. We demonstrate...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.