Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
The finite element model of bump bonding is built and loads with conditions of bonding time, bonding pressure and bonding power at the same time, and the stress and strain analysis of the pad will take place using this bump bonding finite element model. The result show that: the stress and strain distribution of the pad is not even and increasing with the time, the largest stress and strain all locate...
The finite element model of bump bonding is built and loads with conditions of bonding time, bonding pressure and bonding power at the same time, and the stress and strain analysis of the pad will take place using this bump bonding finite element model. The result show that: the stress and strain distribution of the pad is not even and increasing with the time, the largest stress and strain all locate...
The relationship between surface mount component solder joint section area and solder defect, section height and solder defect, contact angle and solder defect were studied respectively. By using dividing method, the contour data of solder joint center section was obtained and the shape parameters of solder center section were calculated. By using the least-square method, regression analysis was carried...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.