Serwis Infona wykorzystuje pliki cookies (ciasteczka). Są to wartości tekstowe, zapamiętywane przez przeglądarkę na urządzeniu użytkownika. Nasz serwis ma dostęp do tych wartości oraz wykorzystuje je do zapamiętania danych dotyczących użytkownika, takich jak np. ustawienia (typu widok ekranu, wybór języka interfejsu), zapamiętanie zalogowania. Korzystanie z serwisu Infona oznacza zgodę na zapis informacji i ich wykorzystanie dla celów korzytania z serwisu. Więcej informacji można znaleźć w Polityce prywatności oraz Regulaminie serwisu. Zamknięcie tego okienka potwierdza zapoznanie się z informacją o plikach cookies, akceptację polityki prywatności i regulaminu oraz sposobu wykorzystywania plików cookies w serwisie. Możesz zmienić ustawienia obsługi cookies w swojej przeglądarce.
Results from two practical and fast methods to estimate systems' Maximum Loading Point (MLP) using Phasor Measurement Units (PMUs) are used in this paper as initial values for a robust and very efficient method that takes advantage of the geometric characteristics of the maximum loading hyperplane and uses the load flow with step size optimization (LFSSO) technique to estimate the system's proximity...
In this paper two different methods to estimate the proximity of the system to the Maximum Loading Point (MLP) are proposed. They are compared with a specific method recently published that uses the Cubic Spline Extrapolation (CSE) for estimating the MLP. All three methods are based on tracking the Thévenin Equivalent (TE) of the system as seen from the load buses using data from Phasor Measurement...
This paper shows that the voltage stability margin of a power network can be determined through the application of a transformation that allows the decomposition of the grid into a set of decoupled source-line-load circuits. By monitoring a small number of these circuits one can analyze the behavior of the actual power system. Therefore it is not necessary to monitor the complete network, since by...
Podaj zakres dat dla filtrowania wyświetlonych wyników. Możesz podać datę początkową, końcową lub obie daty. Daty możesz wpisać ręcznie lub wybrać za pomocą kalendarza.