The objective of this study is to investigate the basic characteristics of the three axis mechanical impedances distributed at the fingers and palm of the hand subjected to vibrations along three orthogonal directions (x h , y h , and z h ). Seven subjects participated in the experiment on a novel three-dimensional (3-D) hand–arm vibration test system equipped with a 3-D instrumented handle. The total impedance of the entire hand–arm system was obtained by performing a sum of the distributed impedances. Two major resonances were observed in the impedance data in each direction. For the hand forces (30N grip and 50N push) and body postures applied in this study, the first resonance was in the range of 20–40Hz, and it was primarily observed in the impedance at the palm. The second resonance was generally observed in the impedance at the fingers, while the resonance frequency varied greatly with the subject and vibration direction, ranging from 100 to 200Hz in the x h direction, 60 to 120Hz in the y h direction, and 160 to 300Hz in the z h direction. The impedance at the palm was greater than that at the fingers below a certain frequency in the range of 50–100Hz, depending on the vibration direction. At higher frequencies, however, the impedance magnitude at the fingers either approached or exceeded that at the palm. The impedance in the z h direction was generally higher than those in the other directions, but it became comparable with that in the x h direction at frequencies above 250Hz, while the impedance in the y h direction was the lowest. The frequency dependencies of the vibration power absorptions for the entire hand–arm system in the three directions were different, but their basic trends were similar to that of the frequency weighting defined in the current ISO standard. The implications of the results are discussed.