The study investigates the ability to remove copper, tin and arsenic from iron ore, scrap and liquid steel based on the literature and thermodynamic calculations using the FactSage 7.2 software. Methods of removing Cu, Sn and As from iron-bearing materials, feasible in industrial conditions in the near term, were selected. Simulation tests with the use of the FactSage 7.2 software showed that under reduced pressure conditions Cu and Sn can be removed from the steel bath, while As evaporation is not possible. Laboratory tests were carried out, including the removal of Sn and Cu in the process of degassing of liquid steel in a deep vacuum in a vacuum induction furnace and the removal of Sn from iron ore in the sintering process. Under conditions of deep vacuum (below 40 Pa), high temperature (1670°C) and a correspondingly long vacuum treatment time (over 30 minutes), the efficiency of removing the copper and tin contents from the liquid steel of approximately 14 and 17% respectively was obtained. The iron ore sintering test with a high Sn content showed the effectiveness of reducing the Sn content during this process, amounting to approx. 30%.
Zbadano możliwości usuwania miedzi, cyny i arsenu z rudy żelaza, złomu i ciekłej stali na podstawie literatury oraz termodynamicznych obliczeń za pomocą oprogramowania FactSage 7.2. Wybrano sposoby usuwania Cu, Sn i As z materiałów żelazonośnych możliwe do realizacji w warunkach przemysłowych w najbliższej perspektywie czasowej. Badania symulacyjne z zastosowaniem oprogramowania FactSage 7.2 wykazały, że w warunkach obniżonego ciśnienia można usunąć Cu i Sn z kąpieli stalowej, natomiast nie jest możliwe odparowanie As. Przeprowadzono próby laboratoryjne, obejmujące usuwanie Sn i Cu w procesie odgazowania ciekłej stali w głębokiej próżni w próżniowym piecu indukcyjnym oraz usuwanie Sn z rudy żelaza w procesie spiekania. W warunkach głębokiej próżni (poniżej 40 Pa), wysokiej temperatury (1670°C) i odpowiednio długiego czasu obróbki próżniowej (powyżej 30 minut) uzyskano skuteczności usunięcia zawartości miedzi i cyny w ciekłej stali, wynoszące odpowiednio około 14 i 17%. Próba spiekania rudy żelaza z wysoką zawartością Sn wykazała skuteczność zmniejszenia zawartości Sn w czasie tego procesu, wynoszącą ok. 30%.