Thin films and coatings are deformed at lower loads than predicted by static tests. The nano-impact technique is a low load impact test capable of revealing marked differences in performance that can be used to optimize the design of coating systems for improved durability. Instead of simply "characterizing" coatings and thin films, their actual tribological performance under "in-service" conditions can now be assessed. Due to very small scale of the experiment and several disturbances, direct interpretation of the results of these tests is difficult. Numerical modelling can simulate the thin films behaviour in the experiment and reveal the real state of strains and stresses. Finite element simulation of the nano-impact test is the main objective of the present work. Simulations were using Forge 2 code adapted to the thin layer conditions. Problems with adaptation and scaling are described in the paper. Developed model will be further combined with the optimization techniques and used in the inverse analysis of the nano-impact tests.
Celem pracy jest rozwój modelu na bazie metody elementów skończonych (MES) do symulacji testów udarności układów twardych nanopowłok. Wymienione testy są wykonywane, aby określić odporność materiału na pękanie. Do przedstawionego w pracy modelu MES nie wprowadzono kryteriów pękania. Pokazano jedynie jak zachowuje się materiał pod wpływem obciążenia udarowego. Trudności prowadzenia symulacji wynikają z małej grubości powłok, konieczności wykonania aktualizacji siatki elementów (remeshingu), wielomateriałowego i wieloetapowego charakteru modelu MES, który musi połączyć różne rodzaje rozwiązań numerycznych jednocześnie. Symulacje wykonano za pomocy kodu FORGE 2, który przystosowano do warunków i wymagań istniejących w układach powłok i w modelowanym matematycznie doświadczeniu. W publikacji zamieszczono wyniki symulacji dla testów udarności opracowanych dla dwóch układów nanopowłok. Wykazano, że stworzony model potrafi przewidywać rozkłady intensywności naprężeń i odkształceń oraz można do niego wprowadzić kryteria pękania, które korzystają z obliczanych w modelu wartości naprężeń i odkształceń.